Grizzly 24" & 27" Resaw Bandsaws G9966 - Manual (Page 29)

24" & 27" Resaw Bandsaws -27-
SECTION 7: MAINTENANCE
V-Belts
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition and operate under proper tension. The
belts should be checked for cracks, fraying and
wear. Belt tension should be checked at least
every 3 months; more often if the bandsaw is
used daily.
The V-belt is accessed via the bottom cover.
Squeeze the center of the V-belt. Note the
amount of deflection. Deflection should be
approximately
3 ⁄
4
".
The table and other non-painted surfaces on the
24" and 27" Resaw Bandsaws should be protect-
ed against rust and pitting. Wiping the saw clean
after every use ensures that wood dust is not
allowed to trap moisture against bare metal sur-
faces.
Tables can be kept rust-free with regular applica-
tions of products like SLIPIT
® . For long term stor-
age you may want to consider products like
Boeshield
® T-9. See the current Grizzly catalog
for these products.
Table
Sealed and pre-lubricated ball bearings require
no lubrication for the life of the bearings. All bear-
ings are standard sizes, and replacements can
be purchased from our parts department or bear-
ing supply store.
As for other items on this machine, such as
adjustment controls, an occasional “shot” of light
oil is just about all that is necessary. Before
applying, however, wipe off any sawdust with a
clean cloth or dry paint brush, and spray on the
lubricant. Ensure that oil does not get on the pul-
leys or V-belt because it could cause belt deteri-
oration and slipping.
Lubrication
Always be aware of the condition of your band-
saw. Routinely check the condition of the follow-
ing items and repair or replace as necessary:
• Loose mounting bolts
• Worn switch
• Worn or damaged blade
• Worn or damaged support bearings or guide
bearings
Miscellaneous
Always disconnect
power to the machine
when performing mainte-
nance. Failure to do this
may result in serious
personal injury.