Grizzly G8621 - Manual (Page 19)

G8621 Heavy-Duty Sliding Table Shaper -17-
Figure 21. Installing the ratchet handle.
Figure 22. Installing the pointer.
4. With the provided washer, thread the ratchet
handle through the miter gauge and into the
table as shown in Figure 21.
5. Insert the the miter gauge pointer shown in
Figure 22, but do not tighten the nearby
setscrew at this time.
7. Slide the clamping unit onto the push shaft
as shown in Figure 24.
Figure 23. Installing the miter fence.
Figure 24. Installing the clamping unit.
6. Place flat washers on the miter fence hex
bolts, then start the special nuts onto the
ends. Slide the special nuts into the groove
of the fence. The end piece for the fence
works with the same special nut and hex bolt
system. When these have all been installed
on the miter fence, it is time to install the
fence onto the miter gauge as in Figure 23.