Grindmaster 890 - Manual (Page 4)

Page 4 Grindmaster Corporation 800 Series Coffee Grinders
Cleaning Instructions
The outside of machine can be cleaned with a damp cloth or common household polishing wax. See
Shear Disc Replacement section in this manual for instructions on assembling and disassembling the grinder
parts. All parts that are in contact with food must be washed with warm soapy water, rinsed,
sanitized and air-dried. Note: The person cleaning the parts should do so with clean hands. Before reassem-
bling, wipe the motor shaft with 2 or 3 drops of common household cooking oil in the area of the feedworm
engagement to make the assembly easier.
Lubrication
All bearings have been oiled for life. No further oiling is necessary.
Figure B
GRIND CAP (ASSEMBLED)
SCREW, 5/16 X 1” LG
SHEAR DRIVE
FEEDWORM & ROTARY BURR
GRIND HEAD
SHEAR DISC
SHEAR COVER
FIGURE : B
ROLL PIN REPLACEMENT
SCREW, 5/16-18 X 1"LG SCREW, 5/16-18 X 1"LG
GRIND CAP (ASSEMBLED) GRIND CAP (ASSEMBLED)
SHEAR COVER SHEAR COVER
FEEDWORM & ROTARY BURR FEEDWORM & ROTARY BURR
GRIND HEAD GRIND HEAD
DWG NO.: 83457 REVISION: REL
ROLL PIN ROLL PIN
Model 890
SHEAR COVER
GRIND HEAD
FEEDWORM & ROTARY BURR
GRIND CAP (ASSEMBLED)
SCREW, 5/16-18 X 1” LG
ROLL PIN