Grindmaster RAPS400E - Manual (Page 10)

Page 10 Shuttle Brewers & Airpot/Shuttle Brewers
Weekly or Bi-Weekly, Depending on Use
1) Fill shuttles with one gallon, 2/3 full, of hot water.
2) Pour into the shuttle liners the recommended concentration of urn cleaner (excessive amounts
of cleaner will attack the stainless steel).
Urn cleaners that have been used successfully:
DIP-IT, manufactured by Economics Laboratories, Inc.
4 Corporate Park Drive
White Plains, NY 10604
OXYLITE, manufactured by Avril, Inc., Syndet Division
601 N. Third Street
Reading, PA 19601
3) Scrub the liner interior with a plastic bristle brush.
4) Remove the knurled nut at the top of the gauge glass and clean the glass with a small
bottle brush.
5) Pour out the contents of the shuttle.
6) Remove the handle assembly of the shuttle faucet by unscrewing the plastic bonnet.
7) Gently wash the faucet seat cup with a soft cloth and warm soapy water.
8) Wash the faucet shank with a bottle brush.
9) Soak airpot pick-up tube assembly in hot soapy water. Urn cleaner may be used for
stronger cleaning.
10) Clean the warmer and bottom of shuttle surfaces. These surfaces must be clean for
proper heat transfer.
11) Polish the exterior of the brewer with stainless steel cleaner. Use the appropriate
cleaner for brass, copper, or vinyl if these optional finishes are provided.
Service
The rest of this manual contains information to aid the service person who is working on this equip ment.
This page has information on performing common service tasks. Following this is the Trou ble shoot ing
section which can help diagnose problems which are divided into three basic systems: filling, heating, and
brew ing.
Next is an illustrated parts breakdown which will help in the selection of repair parts. If further as sis tance
is needed, call our Technical Service Department at (502) 425-2776 or 800-695-4500 (USA & Canada
only) Monday - Friday between 8:00 am and 8:00 pm EST.
Wiring diagrams are also provided. Locate the basic diagram for the model you are working with. If
there are any options, see Diagram #091-548 (page 31 of this manual) which shows the wiring
alterations for Shuttle Brewer & Airpot/Shuttle Brewer options.