Gardena 5000 S - Manual (Page 4)

15
G
14
G
Flushing the Pump :
Cleaning the suction
base and turbine :
5. Cleaning
The pumps are virtually maintenance-free.
After having pumped chlorinated swimming pool water or other
liquids leaving residues, the pump should be rinsed with clear
water.
Warning ! Electric shock !
A
Risk of injury due to electric shock.
V Disconnect the pump from the mains before clean-
ing the suction base and turbine.
1. Unscrew the 3 Phillips screws 8 and pull the suction base 6
off the pump.
2. Clean the suction base 6 and the turbine 9 .
3. Reinstall the suction base 6 and screw in the Phillips screws 8 .
For safety reasons a damaged turbine 9 can only be ex-
changed by the GARDENA Service Centre.
6. Trouble-Shooting
Problem Probable cause Remedy
Pump is running, Air cannot escape, since v Open pressure line
but doesn’t deliver. pressure line is closed. (e.g. kinked pressure pipe).
Air locks in the suction base. v Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
Turbine clogged. v Disconnect plug and clean
turbine (see 5. Cleaning).
When starting the pump, v Submerge pump deeper.
water height falls below the
min. water level.
Pump doesn’t start or Thermal overload switch has v Disconnect plug and clean
suddenly stops during switched the pump off due turbine (see 5. Cleaning).
operation. to overheating. Observe max. media temper-
ature of 35 °C.
No power. v Check fuses and electric
connections.
Dirt particles are jammed v Disconnect plug and clean
in the suction base. suction base (see 5. Clean-
ing).
Pump runs, but output Suction base is clogged. v Disconnect plug and clean
suddenly decreases. suction base (see 5. Clean-
ing).
Attention ! Repairs on electrical parts should only be done by our
GARDENA Service Centres.
If you have any problems with your Pump, please contact our Service.
7. Storage
Store the pump away from frost before the first frost sets in.
8. Technical Data
Type 5000 S (Art. No. 1778)
Rated power 200 W
Max. delivery capacity 5,000 l / h
Max. pressure 0.5 bar
Max. delivery height 5 m
Max. submersion depth 9 m
Flat suction down to approx. 5 mm
Contaminated water with
particle size of max.
5 mm
Power cable 10 m H05 RNF
Pump connection 38 mm (1 1/ 2 ”) / 25 mm (1”) graduated nipple,
option GARDENA Water hose Plug-in-system
Min. water level for operation 45 mm
Weight approx. 4.0 kg
Max. media temperature 35 °C
Mains voltage /
mains frequency
230 V / 50 Hz
Min.cut-in height 380 mm
Min./ max. cut-out height 100 mm / 140 mm
Noise level L
WA
1) 46 dB (A)
1) Measuring method according to EN 60335 -1
The cut-in and cut-out height varies.
The residual water depth (draining in the flat position down
to approx. 5 mm) is only reached during manual operation
(see 4. Operation).
The GARDENA Submersible Pump is manufactured in accordance
with the current electrical safety regulations of the Appliance
Safety Law (GSG) and inspected by the TÜV (German institution
for technical surveillance).
Frost-free storage
9 6 8
Cut-in / Cut-out height
Safety and
Approval