Grizzly G1022Z - Manual (Page 22)

-20- G1022 Series Table Saws
Figure 11. Short upper and lower braces
attached to one of the stand assemblies.
3. Attach the short upper and lower side braces
(2 each) to one of the assembled side pan-
els using M8 - 1.25 x 16 carriage bolts, 8MM
flat washers and M8-1.25 hex nuts as shown
in
Figure 11 .
4. Bolt the stand assemblies together using
M8-1.25 x 16 carriage bolts, 8MM flat wash-
ers and M8-1.25 hex nuts as shown in
Figure 12 .
Models ZF, ZFX, PRO, & PROZX only:
5. Align the bolt holes on the dust hood with the
bolt holes on the dust hood adapter.
6. Secure the dust hood and the dust adapter
together using 10-24 x
3 ⁄
8
" bolts, 10-24 nuts
and 3 ⁄
16
" lock washers.
7. Turn the table saw body upside-down.
8. Place the dust hood assembly over the bot-
tom of the table saw body with the dust hood
flange pointed up.
Figure 12. Stand completely assembled.
Figure 10. Long upper and lower braces
attached to the stand legs.