Stovax Winchester Front PR1018 - Manual (Page 2)

USER INSTRUCTIONS
1. CLEANING AND CONTROLS
1.1 Only clean the front when it is cold. The front should be
cleaned using a damp cloth and buffed with a lint free
duster.
1.2 Access to the controls is behind the ash pan cover.
INSTALLATION
INSTRUCTIONS
These instructions are supplemental to and must be read in
conjunction with the Installation Instructions supplied with the
gas fire. Read both thoroughly before installing the appliance.
Fitting of this front is to be carried out after the appliance has
been fully installed but before the commissioning tests. Except
for use with the E-Box where commissioning will need to take
place prior to fitting the front.
1. FRONT DIMENSIONS
Diagram 1 shows the Winchester Front dimensions for the
Logic hotbox, Logic Convector and Logic IPF:
1
AR2177
508
375 71
337
210
618
55
30
Diagram 2 shows the Winchester Front dimensions for the
E-Box, E-Studio Conventional and Balanced Flue:
USER AND INSTALLATION INSTRUCTIONS
Covering the following front:
Logic 8698 MB
8698 P
E-Box
E-Studio
8697 MB
8697 P
2
AR2178
508
365 71
269
210
618
55
30
40
28
2. FITTING FOR ALL FIRE TYPES
There is a bracket on the reverse side of the front at the top
edge:
• Hook the bracket onto the lugs at the top of the fire,
Diagram 3
3
AR2179
There are two flat clips supplied to grip the bottom edge of the
front to the fire:
• Clip each side of the front to the fire as shown in
Diagram 4
4
AR2180
• Slide the ash pan cover into place
Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG
Tel: (01392) 261999 Fax: (01392) 444148 E-mail: [email protected]
A member of the Stovax Group