Greenway Home Products Muskoka MEF2822CWG - Manual (Page 4)

step 7
If you are using this mantel in a corner application, locate the triangular piece of wood
which attaches to the mantel to create the corner unit. You must attach this piece for
all corner applications. Slide the corner bottom support into the channel located at the
middle of the back of the hearth base. Place the top corner attachment on the floor
upside down. Protect it from damage. Attach the corner upright support to the corner
attachment by lining up the hole in the corner upright with hole in the corner top insert
with 1 nut and 1 lock washer. Simply take the triangle and slide the brackets with the
holes onto the pins which are already attached to the mantel. Once the triangle is
attached, push it up so it is level with the mantel and lock it into place. To lock it into
place simply turn the horizontal wooden blocks attached to the underside of the mantel
into a vertical position to support the weight of the corner triangle. Now attach the corner
bottom support to the corner upright support by insert and tightening 1 wing and 1 lock
washer.
step 8
Take your electric firebox out of its packaging and position it between the 2 legs of the
mantel. Once you are close to the wall, plug the firebox into the nearest outlet.
The firebox comes with 3 metal brackets and 20 black screws. These metal brackets
must be attached to both the sides of the firebox and the mantel to ensure that your
firebox does not move around as you use it. 2 of the brackets have 2 large holes on one
side. These large holes line up with 2 screws on the side of the firebox. The other screws
provided must be inserted into the holes at the other end of the bracket and into the
firebox. The other side of each bracket attaches to the mantel.
The 3rd bracket has no holes on 1 side. That side should go up against the firebox top
but should not be attached as the heater sits right underneath the bracket. Only the
mantel side should be attached.
If you have any questions about the firebox please reference the installation instructions
that come with the firebox. Please reference the Quick Tips section of that instruction
manual.
noTE: some fireboxes come with pre-attached trims
step 9
You are now ready to position your mantel against the wall. This step requires 2 people
to move the unit.
Anti-tipping device
At this point you must attach the anti-tipping device to your mantel and your wall. This
device is a safety feature that will prevent your mantel from tipping over if a weight is
applied which can unbalance the unit.
step 7
step 8
step 9
3