Grizzly G8993 - Manual (Page 5)

Model G8993 4" Tile Saw -3 -
1. KEEP HANDS DRY NEAR
ELECTRICITY. Do not touch elec-
trical connections with wet hands.
2. ALL PLUG AND RECEPTACLES
MUST BE OFF THE GROUND
AND IN A DRY LOCATION.
3. KEEP BLADE WELL
LUBRICATED. Ensure that the
blade remains lubricated with
water when cutting or scribing con-
crete, tile, or stone.
4. WEAR AN APPROVED
RESPIRATOR. Always wear a
NIOSH approved particulate res-
pirator to prevent sillicosis when
cutting or scribing.
5. DISCONNECT THE POWER
CORD WHEN NOT IN USE.
Always disconnect the machine
from the power source before
cleaning, changing attachments or
when performing maintenance of
any kind on this tool.
6. DO NOT WEAR LOOSE
CLOTHING WHILE OPERATING
THIS MACHINE. Tie back long
hair.
7. KEEP HANDS CLEAR. Do not
place hands near, or in contact
with, cutting surfaces during oper-
ation.
Additional Safety Instructions for Tile Saws
8. INSPECT THE TOOL REGULARLY.
Perform machine inspections and
maintenance service promptly as
required.
9. ATTEND TO YOUR MACHINE.
Never walk away and leave the
machine running.
10. KEEP BLADES IN GOOD
CONDITION. Replace or sharpen
blade as needed.
11. USE THE CORRECT BLADES.
Match the correct diamond blade to
the material being cut.
12. INSTALL BLADES PROPERLY.
Check that the directional arrow on
the saw blade points in a clockwise
direction as viewed from the mount-
ing side.
13. INSPECT BLADES REGULARLY.
Before mounting the blade, inspect
the arbor, arbor nut, and flanges
for damage, wear, or looseness.
Replace any damaged or worn
parts.
14. TEST RUN THE MACHINE. Always
test run the machine before starting
any work.