Global Machinery Company GLT25 - Manual (Page 11)

11
• Squeese out the remaining water an allow the filter to
completely dry.
• Add a drop of thin oil to the filter and replace it.
Fuel Filter
• Fuel tank (7) is fitted with a
filter.
• Filter is situated at the free
end of fuel pipe and can be
picked out through fuel port
with a piece of hooked wire or
the like.
• Check the fuel filter
periodically. Do not allow dust
to enter the fuel tank. Clogged filter will cause difficulty
when starting engine or abnormalities in engine
performance.
• When the filter is dirty, replace the filter.
• When the inside of the fuel tank is dirty, it can be
cleaned by rinsing the tank out with petrol.
Checking the spark plug
Check the spark plug every 10-15 hours of use.
1. Remove the spark plug cover.
2. Use the spark plug wrench
to remove the spark plug,
by turning it counter-
clockwise.
3. Clean and adjust the spark plug gap to 0.6 - 0.7mm.
Replace any damaged or visibly worn plug with a
TORCH L8RTC or equivalent spark plug, as listed in the
specifications table.
4. Install the spark plug finger tight in the cylinder head,
then tighten it firmly with the spark plug wrench.
Servicing
• It is recommended once you first use your petrol line
trimmer to get it serviced after 15 hours of use.
• From thereafter, service the petrol line trimmer every
2 years.
Storage and maintenance after use
• When you finish working, clean the petrol line trimmer
completely, making sure there is no grass or dirt
wrapped in the cutting tools, and put it back into its
package in order to avoid its hurting you or other people
during transport.
• Be aware to not hit or cut the fuel tank (7) while
you put it onto the ground. Do not let the petrol line
trimmer fall down to the floor or it may damage the
machine.
• Store the petrol line trimmer away from direct sunlight.
• Do not store in a nylon bag as this can encourage the
formation of mould.
• At the end of the season, give the petrol line trimmer an
overall cleaning and a thorough check.
• Do not leave the petrol line trimmer resting on the floor
for extended periods as it could cause the shape of the
guard to alter, posing a safety risk. Hang it off the floor
by the top handgrip.
Whenever the machine is not used for a long period of
time, proceed as follows:
• Empty the fuel tank completely.
• Protect all metal engine parts from corrosion by coating
them with oil.
2 2