beautypg.com

Parts list – Graco 7950 User Manual

Page 3

background image

6

7

8

5

751-6-99

To Unpack Stroller

Step 1.

Flatten stroller carton to

protect floor.
Open stroller on carton as

shown until latched.

Step 2.

Be sure frame is latched as

shown before continuing

assembly.

Step 1.

Snap swivel lock button onto

wheel mount as shown. This

must be done BEFORE pin is

inserted (next step).

Step 2.

Insert pin through hole in wheel

mount. Then push round end of

a front wheel assembly up onto

pin as shown until it snaps into

place.
Check wheel attachment by

pulling down on the front wheel

assembly.

Step 3.

Repeat above steps for the

other side.

Step 1.

Turn stroller over as shown.

PARTS LIST

CHECK that you have all the parts listed below

BEFORE assembling your stroller.

If any parts are missing, call Customer Service

at 1-800-345-4109 or visit our Internet website,

www.gracobaby.com.

THIS PRODUCT REQUIRES ADULT ASSEMBLY.

No tools required for assembly.

Pin (2)

Rear axle

Frame

Front wheel

assembly (2)

Flattened

carton

Rear

canopy

Front canopy

(only on

some models)

Retainer

(2, 1 extra)

Rear wheel (2)

Cap

(2, 1 extra)

Rear hubcap (2,

only on some models)

To Assemble Front Wheels

Latch

To Assemble Rear Wheels

Swivel lock

button (2)

Spokes

toward

inside

Rear

axle

Retainer (red)

Wide end toward wheel

Hubcap (only on

certain models)

Step 2.

Place ONE rear wheel, red retainer, cap, and hubcap (only on

certain models) on one end of rear axle in order as shown

below. Push red retainer onto axle BEFORE attaching white

cap. Do not place other wheel on axle at this time.

Wheel

Cap (white)

Attach AFTER

retainer is

on axle

Snap red retainer into axle

groove. Then snap cap over the

red retainer as shown.

Be sure

cap is snapped securely over

red retainer.

Snap the hubcap

(only on some models) on last.

Step 3.

Unsnap the basket flap from the

rear brace, and slide rear axle

with wheel assembly through

the hole in one axle bracket.
Continue to push the rear axle

into the hole of the other axle

bracket.

Step 4.

Snap the basket flap around

both the rear axle and the rear

brace.
This may be easier if the

stroller is partially folded.

See the “To Fold Stroller”

instructions.

Step 5.

Place other rear wheel onto the

rear axle. Snap the red retainer

and cap onto the axle as shown

in Step 2.

Step 6.

Only on certain models, snap

the remaining hubcap onto

rear wheel to complete the

assembly.

To Unfold Stroller

Step 1.

Release the latch found on

one side of stroller.

Step 2.

Unfold stroller as shown.

Be certain the

stroller is fully erected and

latched before allowing your

child near the stroller.

To Raise Footrests

Lift footrest and hook wire into

footrest bracket.

To Use Brakes

Always apply

both brakes to park stroller.

Push DOWN to park.

Lift UP to stroll.

Insert pin

Push

wheels up

Round

end

This manual is related to the following products: