GE DBVH520 - Manual (Page 3)

n Properly ground dryer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
n Install or store where it will not be exposed
to temperatures below freezing or exposed
to the weather.
n Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
n Remove the colored protective film from both
the control panel and the door.
n Remove all sharp packing items and dispose
of all shipping materials properly.
n Do not remove the vent protector from the back
of the dryer (on some models).
n Pull the protector out and down to its lowest
position and connect the exhaust duct to the dryer.
The lowered protector will prevent the duct from
getting crushed (on some models).
Exhaust/Ducting:
Dryers MuST be exhausted to the outside to
prevent large amounts of moisture and lint from
being blown into the room.
Use only rigid metal or flexible metal 4″ diameter
ductwork inside the dryer cabinet or for
exhausting to the outside. uSE OF PlASTIC OR
OTHER COMBuSTIBlE DuCTWORk CAN CAuSE
A FIRE. PuNCTuRED DuCTWORk CAN CAuSE A
FIRE IF IT COllAPSES OR BECOMES OTHERWISE
RESTRICTED IN uSE OR DuRING INSTAllATION.
For complete details, follow the Installation
Instructions.
2
1
3
PROPER INSTALLATION
This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting GEAppliances.com, or by calling 800.GE.CARES (800.432.2737).
Co
ns
um
er
S
up
po
rt
Tro
ub
les
ho
ot
in
g T
ip
s
O
pe
ra
tin
g I
ns
tru
cti
on
s
Sa
fe
ty
In
str
uc
tio
ns
GEAppliances.com