GE 200D9366P019 - Manual (Page 22)

Installation Instructions
REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location or
reversal of the handles – on some models)
Stainless steel (on some models):
REMOVING
THE DOOR HANDLE:
Loosen the set screws
with the 3/32″ Allen
wrench
and remove
the handle. NOTE: For
Double Door models
follow the same
procedure on the
opposite door.
Plastic handle (on some models):
REMOVING THE DOOR HANDLE: Depress the tab on
the underside of the handle and slide the handle up
and off of the mounting fasteners.
REVERSING THE DOOR HANDLE (on some models):
• Remove
the handle
mounting
fasteners with
a 1/4″ Allen
wrench and
transfer the
handle
mounting
fasteners to the
right side.
• Remove the logo
badge.
• Remove and
transfer the
plug button to
the left side of the fresh food door. NOTE: Use a flat
plastic edge to prevent damaging the door. Remove
any adhesive on the door with a mild detergent.
Remove the paper covering on the adhesive
backing on the logo badge prior to carefully
attaching the badge to the door.
A
A
6
A
B
A
B
Mounting
Fasteners
Mounting
Fasteners
Badge
Badge
(appearance may vary)
(appearance may vary)
REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
Loosen the set screws located on the underside of
the handle with a 1/8″ or 3/32″ Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4″ Allen wrench.
A
7
A
22
INSTALLING THE REFRIGERATOR
(cont.)