Controls and features, Controls and features , 9, Remove packaging – GE ZDI15 User Manual
Page 8: Set controls, Clean before using
8
Controls and Features
Icemaker
Remove
packaging
IMPORTANT:
Do not remove any permanent
instruction labels inside your icemaker or the
Tech Sheet that is fastened behind the lower
access panel.
• Remove tape and any labels from your
icemaker before using (except the model
and serial number label).
To remove any remaining tape or glue, rub
the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing
alcohol, flammable fluids or abrasive
cleaners to remove tape or glue. These
products can damage the surface of your
icemaker. For more information, see
Important Safety Instructions
.
Set controls
1.
To start the normal ice making cycle,
select ON.
2.
To stop icemaker operation, select OFF.
NOTE:
The CLEAN setting is used whenever
solutions are circulated through the icemaker
for cleaning. See Care and Cleaning.
Clean before
using
After you remove all of the packaging
materials, clean the inside of your icemaker
before using it.
See the cleaning instructions in Care and
Cleaning.