GE JGP985 - Manual (Page 20)

PREPARING FOR INSTALLATION
Installation Instructions
TOOLS AND PARTS NEEDED
• Large flat-blade screwdriver
• Phillips screwdriver
• 3/8
″ socket and ratchet
• Saw
• Carpenter’s square
• Pipe wrench
• Gas line shut off valve
• Pipe joint sealant for use with gas connections
that resists action of LP gas
For flexible connection where local
codes permit:
• Flexible metal tubing (same 3/4
″ or 1/2″ I.D. as
gas supply line)
• Flare union adapter for connection to supply line
(3/4
″ NPT x 3/4″ I.D. or 1/2″ NPT x 1/2″ I.D.)
• Flare union adapter for connection to regulator
(1/2
″ NPT x 3/4″ I.D. or 1/2″ I.D.)
For rigid connection:
• Pipe fittings as required
Tie down bolt
on each end
Grease Container
Pressure Regulator
Wiring Box Cover
29 ″ ± 1 ⁄
16
″
*Blower can be swiveled 90°
9 ″
9 1 ⁄ 2
″ 1 7 ⁄ 8
″ Min.
4.76 cm
15 ⁄
16
″
21 ″ ± 1 ⁄
16
″
Minimum
Clearance
73.66 ± .16 cm
24.13 cm
2.38 cm
22.86 cm
53.5 ± .16 cm
14 3 ⁄
16
″
36.04 cm
IMPORTANT
Motor Clearance—Provide 2
″ min. (5.1 cm) cabinet
clearance to motor for cooling purpose.
NOTE:
Where possible, 6
″ (15.2 cm) is
recommended for motor/blower service.
Side Clearance—Grills installed near a side wall
should allow a minimum clearance of 8
″ (20.3 cm).
You must allow room enough to remove and empty
grease container(s).
CAUTION:
Warranty is void on equipment installed
other than as recommended by GE. Recommended
wall caps and transitions must be used for proper
operation and installation.
20
* Blower may be rotated for horizontal or vertical direction by loosening nuts around
blower inlet. Accessible inside ventilation chamber.
4 3 ⁄ 16
″ 10.64 cm
18 1 ⁄ 2
″
47 cm
Minimum
Clearance
2 ″
5.08 cm
Minimum
Clearance
14 1 ⁄
2
″
36.83 cm
12 7 ⁄
8
″
32.7 cm
Grease
Container
Appliance
Pressure
Regulator
Select appropriate duct
cutout. (See ducting
installation instructions.)
PREPARATION