Grizzly FLOORING STAPLER H5977 - Manual (Page 9)

Model h5977 (Mfg. since 2/07) -8 -
this stapler may accidentally fire if
you work on it without disconnecting
it from the air supply. always discon-
nect air from stapler whenever clear-
ing a jammed staple!
to clear a jammed staple from the dis-
charge area on the model h5977:
1. disconnect the stapler from the air
supply!
2. pull the magazine loader all the way
back and remove the staple stick.
3. the jammed staple should now be
visible; remove it from the discharge
area with needle nose pliers.
clearing Jammed staples cleaning stapler
use a good solvent to clean the nose
assembly of the stapler. always be sure
that the stapler is dry before using it
again.
do not allow dust, chips, sand, etc. into the
air connectors or into the body of the sta-
pler; this may result in leaks and damage
to the stapler and the air couplings.
vapors from cleaning with gasoline
or flammable liquids could ignite and
cause an explosion. never use highly
flammable liquids to clean the stapler
and thoroughly dry all cleaned parts
before reassembling or operating.