Global Machinery Company MX355C User Manual

Page 8

Overview

The cut off saw is used for cutting steel such as pipe, box

section, rectangular, angle iron and steel bars. The saw

can cut at angles from 0° to 45° left and right, it features

a three position fence that permits an extended cutting

range. The quick release vice allows fast adjustment whilst

the lock-off button prevents accidental operation.

Attaching the rubber feet

1. Tilt the saw onto its side.
2. Take the rubber feet and

insert 1 rubber foot into the

matching slots on the base

of the saw (fig A).

3. Ensure the rubber feet are

fully inserted into the slots.

4. Repeat for the other side

and place the chop saw back on its base.

Attaching the vice handle

1. Fit the vice handle onto the end of the vice (fig B).
2. Fit the spring washer over the hex screw followed by

the flat washer.

3. Place the hex screw inside

the vice handle and secure

the vice handle to the vice by

tightening the hex screw in a

clockwise direction (fig C).

4. Fit the cap onto the vice

handle (fig D).

Attaching the rear spark shield

1. Place the spring washer over

the hex bolt followed by the

flat washer (fig E) and then

fit the hex bolt through the

spark deflector. Place the

spark shield in the correct

position (fig F) and tighten

the hex bolt.

2. Tighten the hex bolt to secure

the spark shield in position

(fig G).