Grizzly G1023 - Manual (Page 18)

G1023 Heavy-Duty Table Saw -17-
Figure 23.
5. Loosen the jam nut behind the 45° stop bolt.
Tighten or loosen the stop bolt to adjust the
stopping position of the arbor. Tighten the
jam nut.
6. Tilt the blade until the 45° stop bolt prohibits
movement. Check the angle of the blade.
7. Repeat steps 3-6 as necessary.
45° Stop Bolt
45˚ Positive Stop
To adjust the 45° positive stop bolt:
1. Turn the arbor tilting handwheel (the one on
the left side of the saw) until the 45° positive
stop limits movement.
2. Check the angle of the blade to the table with
a high quality angle gauge.
Figure 22. If the
blade is 45° to the table, you are finished. If
the blade is not exactly 45° to the table, pro-
ceed to the steps below.
3. Angle the blade toward 90° to allow access
to the stop bolt.
4. Locate the stop bolt on the geared trunnion
inside the cabinet. It is accessed through the
hole in the side of the cabinet behind the
blade height hand wheel.
Figure 23.
Figure 22.
Jam