Graco Baby Accessories - Manual (Page 56)

4.2 Removing and Attaching Infant Restraint
4.1 Adjusting Handle
To remove, squeeze release handle at back of
infant restraint and lift out of base as shown ➌.
To put infant restraint in base, push infant
restraint down until it clicks into base. Pull up
on infant restraint to be sure it is latched
firmly into base.
➌
1. Press handle adjustment buttons on both
sides of handle ➊.
2. Rotate handle until it clicks into any of the
4 positions:
Position
A: MUST be used
when carrying by handle,
Position B,C: are convenience
positions,
Position D: is the sitting position,
NEVER use position B in
the vehicle.
BOTH handle adjustment
buttons must pop out to lock
handle in place ➋.
3. Push and pull on the handle to
be sure it is locked firmly in
position.
➊
➋
Carrying
Sitting
A B
C
16
D