Connections, Tv connections battery connections – GoVideo 525p User Manual

Page 8

Connections

��

TV Connections

Battery Connections

Charging the Battery

• Attach the supplied battery pack to the back of the portable DVD player.

• Plug the supplied AC adapter into a standard power outlet, and then connect it to the DC IN 12V jack on

the left side of the player.

• Turn off the player. The battery pack will NOT charge while the portable DVD player is powered on.

• The red “Batt Chrg.” light will glow while the battery pack is charging and will turn green when fully

charged. Allow several hours to charge the battery pack.

• When fully charged the battery will last ~2.5 hours.

Removing the Battery

• Press the PUSH button to remove the battery pack.

Standard AV Connections

• Connect the supplied audio/video

cable (mini-plug to RCA) from the AV

OUT jack to the Audio/Video Inputs on

our television.

• Slide the AV OUT/AV IN switch to the

AV OUT position.

CAUTION

• Use speciﬁ ed charger only.

• May explode if battery is incorrectly replaced or disposed of in ﬁ re.

• Do not short circuit.

• Danger of explosion if battery is incorrectly replaced. Replace only with the

same or equivalent type.

• Do not place the battery pack under direct sunlight or in excessively hot places

(over 60°C (140°F)) such as the dashboard of cars.

• Only use with the speciﬁ c power adapter by manufacturer.

• The battery pack will not charge while the DVD player is turned on.

S-Video/Progressive Scan Connections

For improved picture quality:

• Connect an S-Video cable with mini-plug

adapter (not included) from the S-VIDEO/

P-SCAN jack to the S-Video input on your

television.

• Connect a Component Video cable with

mini-plug adapter (not included) from the

S-VIDEO/P-SCAN jack to the Component

Video input on your television.

• Slide the AV OUT/AV IN switch to the AV

OUT position.

• Press the MODE button to switch between

S-Video and Progressive Scan modes.