Global Machinery Company 360W MAGNESIUM ALLNAILER ACALN - Manual (Page 7)

Frequently Asked Questions
Q: Do I need to use special nails?
A: No. You can use any loose nail within the range specifications
Q: Can I run the tool continuously?
A: No. at stated in the manual, it’s 10sec on and 10 sec off/rest
Q: Will the depth control be the same for all materials?
A: No. The same setting will vary depending on depth, nail spec and material.
You should do a couple of test runs first.
Q: Is the ACALN suitable for finishing projects?
A: Not if you are not countersinking and filling the nail heads as their will be
some very minor marks left after each nail.
Q: Does the tool actually shoot nails out?
A: No. It works similarly to a hammer, where an internal mechanism impact the nails
head at high speed to drive the nail in.
Q: Sometimes the nails are not driven in all the way as per the nail range specification.
A: Even same species of timber can have varying densities and the nail range specified
can there-for be a guide only.
ACALN – AC AllNailer