Gossen SI 232-II - Manual (Page 3)

GOSSEN METRAWATT GMBH 3
1 Introduction
Interface Adapter
Whereas interface adapter BD232 allows for online transmission of measured values from
multimeter to PC, memory adapter SI232/-II is additionally capable of saving multimeter data
on-site without a PC. The values thus stored to memory can subsequently be transmitted to
a PC.
PC-Analysis Software
METRAwin 10 is a high-performance analysis software for use with WINDOWS.
It allows for user-friendly recording, storing, display and documentation of measurement
data from up to 10 multimeters.
Data display is possible in multimeter, recorder or data logger format.
Measurement data are saved in ASCII format for further processing.
The required operating language can be selected for the software.
Upon request we can supply you with an interface description for our multimeters to enable
programming of your own Windows applications.
If you would like to use our multimeters together with LabView software from National Instru-
ments, the corresponding driver is available from our product support team, see chapter 11.
2 System Requirements as from software version 5.0 (32 Bit)
Software
– MS WINDOWS 95/98/ME, NT or 2000
Hardware
– IBM compatible WINDOWS PC, Pentium-CPU or better with 32 MB RAM
– VGA monitor
– Hard disk with at least 20 MB available memory
– 3½“ floppy disk drive
– MICROSOFT compatible mouse
– a WINDOWS supported printer, if required
– 1 serial interface COM1 or COM2