English – Vitek VT-1377 BK User Manual

Page 5

RECHARGEABLE SHAVER

DESCRIPTION
1. Protective

cap

2. Shaver

block

3. Rotating

blades

4. Blade

drive

5. Shaver block locking button
6. Shaver

housing

7. Power switch with locking button
8. Charging

indicator

9. Charger
10. Cleaning brush
11. Travel bag

Charging (Fig.1)
Before using the shaver for the first
time or after a long period of disuse, it
should be charged for 6 hours.
- Insert the charger plug (9) into the

charging socket on the bottom side
of the housing and connect the
charger to the electrical network;
the charging indicator (8) will light.

- Supplemental charging cycles of

the rechargeable battery should
not exceed two hours.

Attention!
- Do not charge the rechargeable

batter for more than 10 hours or
in temperatures lower than 0°C or
higher than 40°C, as this can cause
damage.

- If the shaver is not used for more

than 20 days, then it should be
charged for six hours.

Using the shaver
The best shaving results are achieved
if your skin is dry.

Your skin may need 2-3 weeks to
adapt to this shaving system.
- Remove the protective cap (1).
- Turn on the switch (7).
- Lightly touch the skin, moving

around the shaving block using
simultaneous up-down and rotat-
ing motions.

- Turn off the shaver with the power

switch (7), cover the shaving block
with the protective cap (1) and
store the shaver.

Using the trimmer (Pic. 2, 3)
The trimmer is designed for evening
whiskers and caring for mustaches.
- Move the trimmer switch to the

upper position.

- Turn on the shaver with the switch

(7).

- Position the shaver at the correct

angle to the skin and move it gradu-
ally down, evening the whiskers.

- Turn off the shaver and move the

trimmer switch to the lower posi-
tion.

Cleaning the shaver
- Press the shaving block locking but-

ton (5) to open the shaving block
and gain access for cleaning (Pic.
4).

- Using the brush (10), clean the

shaving block inside and out, and
also the blade drive (Pic. 5).

- The shaving block can be washed

under a stream of warm water (Pic.
6). Dry the shaving block com-
pletely before closing. Do not allow
water into the electric shaver's
body. After completely dry, close

ENGLISH

1377.indd 5

28.02.2006 10:36:40