User instructions, Maintenance – Stovax Electric Stove Range User Manual
Page 5

5
2.6 THERMAL SAFETY CUTOUT
The appliance is fitted with a thermal safety cutout, which
operates if it overheats. If this occurs you notice the
heater is cold. If this happens:
• Unplug and allow the heater to cool for 5 - 10 minutes
• Check the air inlets/outlets for any obstruction and clear,
see Maintenance
• Plug in, switch on the fire and the cutout now re-sets
The appliance should function correctly again but if this is not
the case:
• Unplug once more and have the fire checked by a
competent electrician
Please note that the safety cutout will activate when the
fan heater is turned off. If the fan heater is turned back on
immediately, you must wait 15 seconds before the heater
warms the air.
• Remove the loose fuels from the glass fibre fuel bed
3. MAINTENANCE
ALWAYS UNPLUG FROM MAINS SUPPLY BEFORE
CLEANING OR UNDERTAKING ANY MAINTENANCE
REPLACING LAMPS
3.1 If the lamp bulb fails to light you will notice an uneven or
unlit fuel effect and you can change the lamp:
• Switch off the appliance and isolate it from the mains by
unplugging the unit
• Wait for at least 10 minutes until the appliance has
cooled down
• Unscrew the bulbs
Only use fused 40W Elegance Soft E.S. (E14) candle lamps
available from Gazco dealers and most electrical shops
3.2
To remove the door, glass front and fuel bed and access the
lamps, choose the instruction corresponding to your model
from Section 4 below.
3
AR2160
USER INSTRUCTIONS
3.3 CLEANING
Only clean the outer casing when it is cold. Do not use
abrasive cleaners.
For painted castings, wipe with a damp cloth and buff with a
lint free duster.
3.4 CLEANING AIR INLETS
• Ensure the appliance is unplugged
• Clean the air inlet and outlet grills regularly with a soft
cloth or the nozzle of a vacuum cleaner
Dust build-up can inhibit efficient performance of the fan
and lead to the safety cut-out operating:
• Keep the area around the stove clean and free of fluff,
dust or pet hair
• In particular, build-up of dust etc. can occur around the
heater area under the stove. Take particular care to keep this
area free from such particles on a regular basis to prevent
build-up.
3.5 CLEANING LOG MOULDING
• Make sure the appliance is unplugged
• Take the log moulding out to clean away from the
appliance. Follow Section 4 below to access log
moulding
• Dust off any build-up with a brush or damp cloth -
replace