Gold's Gym GGTL03607.3 User Manual

Page 19

Remove the three M4.2 x 19mm Washer Head

Screws (13) and carefully pivot the Hood (53) off.

Locate the Reed Switch (54) and the Magnet (42)

on the left side of the Pulley (44). Turn the Pulley

until the Magnet is aligned with the Reed Switch.

Make sure that the gap between the Magnet and

the Reed Switch is about 1/8 in. (3 mm). If neces-

sary, loosen the M4.2 x 19mm Screw (1), move the

Reed Switch slightly, and then retighten the Screw.

Reattach the Hood (not shown), and run the tread-

mill for a few minutes to check for a correct speed

reading.

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-

move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the

maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 11.

b. If the walking belt is overtightened, treadmill perfor-

mance may decrease and the walking belt may be-

come damaged. Remove the key and UNPLUG THE

POWER CORD. Using the hex key, turn both rear

roller bolts counterclockwise, 1/4 of a turn. When the

walking belt is properly tightened, you should be able

to lift each edge of the walking belt 2 to 3 in. (5 to 7

cm) off the walking platform. Be careful to keep the

walking belt centered. Then, plug in the power cord,

insert the key, and run the treadmill for a few min-

utes. Repeat until the walking belt is properly tight-

ened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

Top

View

1/8 in.

Rear Roller Bolts

2–3 in.