Graco ISPA118AC User Manual

Page 58

Text mode
Original mode

• Combination Lap/Shoulder

Belt with Sliding Latch Plate

This belt has a latchplate that
slides freely along the belt.

This belt MUST be converted to prevent
movement of the lap portion of the belt. You
must use the locking clip provided with the
infant restraint, unless your vehicle's seat belt
can be converted in another way as described in
your vehicle owner's manual.

To Install Locking Clip:

1. Tighten the buckled belt by pushing down

hard on the infant restraint and pulling
hard on the shoulder belt.

2. While pushing down on infant restraint,

pinch the two straps together behind the
buckle tongue. Unbuckle the belt
without allowing it to slip.

3. Connect lap and shoulder belts

with locking clip as shown
and

4. Rebuckle belt. Check that lap belt

does not move by pulling and
pushing hard on infant restraint.
If belt loosens or lengthens,
repeat procedure.

Locking clip

inch

Locking clip goes here,

inch from the buckle