beautypg.com

Problem solution – Guardian Technologies PUREGUARDIAN H1600 User Manual

Page 4

background image

E-6

E-7

ProBLEM

SoLUtioN

Water mist and humidity

are not produced.

Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Water Tank Installation: Make sure the water tank is

correctly attached. Make sure spring on tank

cap moves freely when pushed.

Air blows but water mist

is not produced.

Excessive Water: Remove water tank. Empty a

small amount of water from the base of the unit.
The desired humidity is lower than the current

temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out

and try again.

Humidity level is low.

The surface of the ultrasonic disk is dirty. Clean

with white vinegar.
The water in the unit is too cold: Replace with cool,

but not cold water.
If ultrasonic disk is damaged contact

customer Service at 1.866.603.5900.

Warm humidity is not produced.

It may take 10-15 minutes before warm

humidity is created. The mist may not feel

warm to the touch.
Check to see if base of unit feels warm to the touch;

if so then warm mist is being produced.

The humidity has a bad smell.

Poor maintenance or dirty water: Clean the product

thoroughly, and fill it with fresh water.

White dust is forming on

nearby furniture.

Hard water will deposit a certain amount of

dust. Dust in the air settles because of the

added humidity in the room.

*Use distilled water if this becomes a nuisance.

Or order a Decalcification Filter (FLtDc)

by calling 1.866.603.5900 or

visiting www.guardiantechnologies.com.

Always unplug the unit before servicing it in any way.

The temperature of the water remaining in the unit after use may be HIGH.

Do not submerse the unit in water, or allow water to enter the inside of the unit or humidity

spout. Only put water into the water tank.

iNSiDE tHE BoDY oF tHE UNit

Pour excess water out of the unit, but do not allow it to enter the spout guide. Wash

out the unit with fresh water, using ONLY the cleaning brush and a soft cloth as needed.

oUtEr SUrFacE oF tHE UNit

Wipe the surface of the unit with a soft, damp cloth if needed.

WatEr taNK

If water spots remain in the water tank, wipe the inside with a soft cloth.

DO NOT use soap or detergents.

ULtraSoNic DiSK

Remove water tank (Fig. 1) and use the enclosed cleaning brush to regularly remove build up

and deposits from this area (Fig. 2). Diluted white vinegar will help to prevent this build up.

Fig. 1

Fig. 2

Fully dry the inside and outside of the unit before storing it.

DO NOT leave water in the unit.

Store in a cool, dry place.

9.

Night

Light

Feature

Press the Night Lamp button at

the top of the unit to illuminate

the night light feature.

10.

Water refill Button

When the Water Refill button lights

up it is time to refill the water tank.

11.

Humidity Spout Direction

To change the direction of

the mist turn humidity spout

as desired.

*clean the disk with

the brush only. No

other cleaning tool

should be used.

Brush only. (Fig. 2)

This manual is related to the following products: