Golden Technologies GA 531 - Manual (Page 31)

Avenger Owner’s Manual
CARE AND MAINTENANCE
Wheels and Tires
Your Avenger
™ scooter is equipped with pneumatic tires with “split-rim” wheels.
WARNING: NEVER DISASSEMBLE WHEELS UNLESS ALL OF
THE AIR HAS BEEN RELEASED THROUGH VALVE STEMS.
How to change a tire assembly:
1. Remove the center nut.
2. Remove the tire assembly from the scooter
3. Install a new tire assembly onto the axle.
4. Install and tighten the center nut.
NOTE: All tires on your Avenger
™ are pneumatic.
IF YOUR AVENGER
™ DOES NOT OPERATE
• Make certain that the brake handle is set to the engaged (forward)
position.
• Check the main circuit breaker. If necessary, reset the circuit breaker.
• Make certain that the speed adjustment dial is at the desired setting.
• Be sure that the key is all the way in the key receptacle and the scooter is
“ON” (note, the green “LED” light is illuminated)
IF NONE OF THE ABOVE PROCEDURES SOLVE THE PROBLEM, CONTACT
YOUR AUTHORIZED GOLDEN TECHNOLOGIES DEALER.
LUBRICATION
All of the bearings on your Golden Avenger
™ are permanently lubricated and
sealed.
•
No lubrication is required
•
Do not lubricate the motor or transaxle.