Guardian Technologies R2000 - Manual (Page 3)

4 5
!
WARNINGS
This product should be used only in accordance with the specifications outlined in this
manual. Usage other than what has been specified here may result in serious injury.
· Disassembly, repair or remodeling by an unauthorized person may result in serious harm.
· Do not use if plug is damaged or loose.
· Keep this product out of the reach of children and pets.
· Be careful not to put water in the humidity spout.
· Before filling or cleaning the unit, make sure it is unplugged.
· Once the humidifier has been turned on, do not move it.
· Do not remove the water tank from the unit while it is on.
· Do not handle the plug with wet hands.
· Do not excessively bend, twist or pull the power cord.
· Avoid placing this product where the humidity spout is pointed directly at an object.
· Do not directly inhale the humidity spout.
· Do not place this product on a sloped or unstable surface.
· When not in use, unplug the unit.
· Do not fill the water tank with hot or boiling water.
· Do not use this product in direct sunlight, or near a gas stove or heater.
· If the water tank becomes cracked or damaged, do not use.
· Do not keep this product running for an extended period of time.
· Do not clean the unit or water tank with detergents or chemicals of any kind.
· Do not use this product near any other electronic device.
· Do not cover the humidity opening at any time during use.
· Do not use this product near a sink.
· Do not drink water from tank.
· Do not place this product on an absorbent surface.
Failure to comply with the warnings listed above may result in electric shock or serious injury.
DIRECTIONS FOR USE (cont.)
3. Pour cool, clean water directly
into the tank. Do not pour
anything but water into the
water tank.
4. Close the tank lid, turning it
to the right.
5. Attach the tank to the body
of the unit and plug in.
8. As soon as the Refill LED lights
up, turn the unit off and refill
the water tank.
DIRECTIONS FOR USE
Make sure the unit is unplugged.
1. Separate the tank from the
body of the unit.
2. Open the tank lid, turning it
to the left.
6. To select the temperature of
humidity turn the mode dial
to cool or warm. The Power
LED will light up.
7. Turn the spray volume knob to
the right to increase mist/humidity
level. Turn left and the humidity/mist
level decreases.