Grizzly G5959Z User Manual
Page 25
G5959Z 12" Left-Tilting Table Saw
-23-
CLAMPING PRESSURE
The fence-clamping mechanism has been adjust-
ed at the factory to provide the right amount of
clamping pressure to hold your fence securely.
Should it eventually need adjustment:
1.
Loosen the clamping arm.
2.
Remove the fence from the saw and adjust
the setscrews equally on the rear side of the
front bracket as shown in
Figure 28
.
3.
Replace the fence and check the clamping
strength. Re-adjust until proper pressure is
ensured.
Figure 28.
Setscrew adjustments.
PARALLELISM
Align the fence alongside the miter slot as shown
in
Figure 29
, and lock it down. If the fence is not
perfectly parallel to the miter slot:
1.
Release the clamping mechanism.
2.
Remove the fence from the saw and adjust
the setscrews on the rear side of the front
bracket as shown in
Figure 28
. Make very
minor adjustments and recheck by reclamp-
ing the fence along the miter slot after each
adjustment. Keep in mind that a small turn of
the setscrew can make a large difference
over the length of the fence. Be sure clamp-
ing pressure is still adequate.
Figure 28.
Fence aligned parallel to miter slot.
Setscrews
Nylon Pads