Gaggia Coffee Deluxe User Manual

Page 16

ENGLISH

Making hot water:

1. Follow the procedure described under

Preparation.

2. Turn the power switch (1) to 1.
3. Allow about 6 minutes for the machine to reach

its proper operating temperature.

4. Place a pitcher under the steam nozzle (8).
5 Turn the hot water/brew switch to 1 and

slowly turn steam valve knob (7) counter

clockwise to release hot water.
N.B.: Dispensing should not exceed 60

seconds.

6 When you have prepared the desired

quantity of hot water, turn steam knob

clockwise and hot water/brew switch to 0

to shut off hot water and remove pitcher.

7 NOTE: If you want to make espresso

immediately after making hot water, the tem-

perature of the machine boiler must be

brought down to a brewing temperature.

Otherwise, espresso may taste burned.

Keeping it clean:

1 IMPORTANT: the steam nozzle should be

cleaned after each use in order to avoid build

up of milk deposits that are very difficult to

clean. Cleaning is made easy as can be seen

in the DESCRIPTION OF PARTS. The outer

part of nozzle can be removed by pulling

downward.
The outside of the steam pipe can be cleaned

with a damp cloth.
The steam jet is cleaned by running a shot of

steam through it.
The hole in the steam nozzle must be kept

open. A needle may be used.

2 Clean filter holder and filter in warm water

after use.

4 Slowly turn steam valve knob (7) counter

clockwise to release steam.
IMPORTANT: The more you turn the

knob, the greater the steam pressure for

frothing.

5 When you have made enough froth, turn

steam knob clockwise to shut off steam.

Put steam switch (4) to 0 position.

6 Top each cup of cappuccino with a dash

of cinnamon, cocoa, nutmeg. Serve.

7 NOTE: If you want to make more espres-

so immediately after steaming milk, the

machine boiler must be refilled with water

and temperature brought down to a

brewing temperature.

Otherwise, espresso may taste burned.

To do this: place an empty cup on the drip

plate.

Do not insert filter holder.

Turn hot water/brew switch (2) to 1

letting cup fill with water.

Turn brew switch 0.

You may now proceed to make more

espresso.

To do this: place an empty cup on drip plate.

Do not insert filter holder. Turn hot water/

brew switch (2) to 1 letting cup fill with

water. Turn brew switch 0.
You may now proceed to make espresso.

max

Pay attention as the

Turbo-Frother

steam nozzle

could be hot!