beautypg.com

Fitting and removing the battery pack, Battery charging – Global Machinery Company GTX24250 User Manual

Page 9

background image

9

Fitting and removing the battery pack

To remove the battery pack from the drill firmly press the

battery release tabs (7) at either side of the battery pack,

and slide the battery backward out of the tool.
To install the battery pack, align rails, on the tool with the

tabs on the battery pack and

slide the battery pack on to

the drill. Ensure the battery

pack is sitting straight on the

foot and correctly entering

the runners. The battery

should slide fully on to the

drill foot until the battery

pack “clicks” into position.

Battery charging

1. Connect charger (9) to

power source. The green

light (a), should light up.

This indicates the charger

is ready to begin charging.

2. Position battery pack on

charger, align rails (d),

on battery charger with

(e) on battery pack. Slide

battery forward onto

charger until it clicks into

position.

3. The red light (b), should

begin to glow continuously,

indicating that the battery

pack is receiving a “Fast

Charge”.

4. After approximately one hour, the “Fast Charge” indicator

red light (b) should go out indicating that the battery

pack is fully charged and that the charger is now in a

“Maintenance Charge” mode, this is confirmed by the

light (a) coming back on. The battery pack can be left

on Maintenance Charge” until you are ready to use it.

5. To remove the battery pack from the charger depress

the battery pack release buttons (6) and slide the

battery off.

Warning.

Do not leave batteries charging for longer than

24 hours.

Note.

Depending on room temperature, line voltage, and

existing charge level, initial battery charging may take

longer than one hour.

Note.

Disconnect charger from power source when not

in use.

To obtain the best life for the battery

Never allow the drill to come to a complete stand still

before recharging. The battery should be placed on charge

whenever the battery is noticeably running down or the

drill no longer performs a task it previously performed.
Avoid conducting short charges. Make sure that the battery

is fully charged every time by allowing the charger to

complete its full charging cycle.
Avoid allowing lose items like screws or nails etc to be

stored with battery packs as these or similar items can

short battery packs and cause a fire or explosion.

e

b

a

d

This manual is related to the following products: