Globalsat Technology Globalsat BT-328 - Manual (Page 5)

BT-328 User Manual
page 5 of 10
6. Getting Started
Turn the device on and off
Power on: Press the power button for 1 second until the GPS status LED is on.
Power off: Press the power button for 1 second until the GPS status LED is off.
AC Adapter jack
The power jack allows you to connect either a DC car charger (included) or AC adapter
(included) to recharge the internal battery. Please note that the adapter is rating 5V, 1.2A,
positive pole center.
LED Function
Power Status LED (Red / Yellow):
Red Battery power is critically low, please charge it immediately.
Yellow Battery is charging now.
LED off Battery is partially full or fully charged.
GPS Status LED (Green):
Blinking GPS position is fixed.
On GPS position is not fixed.
Bluetooth Status LED (Blue):
Blinking slowly
(flash once in every 3 seconds)
Not connected to any Bluetooth device. (Standby
mode)
Blinking quickly
(flash once in every second)
Connected to a Bluetooth device. (On-line mode)
Power-saving Function
After you have turned on the power of BT-328, and if it was not connected to any
Bluetooth device within 10 minutes, BT-328 will turn off the power automatically by itself.
If the AC adapter is connected, this function will be disabled.