Global Machinery Company NTS2000A - Manual (Page 10)

10
13. Position the hook on the
front of the bench grinder
support plate and secure
using the pan head screw
and flat washer.
WARNING! DO NOT fit the
bench grinder to the stand until
the stand is bolted through
or into the floor. This stand
is not designed to be a free standing stand, and the base
must be secured to the floor or area where the stand will
be positioned. Do not fit the grinder or operate the grinder
without the base being firmly attached as it will tip over.
Adjusting the height
WARNING. Always ensure that the bench grinder is
removed from the bench grinder support plate before
adjusting the height.
1. Loosen the tension handle.
2. Whilst holding the bench grinder support plate rotate the
support plate in a clockwise direction to disengage the
height location.
3. Raise or lower the support plate to the desired height.
4. Rotate into the nearest height location by rotating the
support plate in an anti-clockwise direction.
5. Tighten the tension handle to secure the pole and support
plate in position.
IMPORTANT. It is important to ensure the adjustable stand is
correctly located into one of the pre set height positions. Do
not attempt to use the stand if it is not correctly located.
Cleaning
1. Re-lubricate all moving parts at regular intervals.
2. Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Trouble Problem Suggested remedy
Vibration or
abnormal noise
Loose parts Check to see that all
screws are secure.
Troubleshooting