Grizzly G1073/G1073Z - Manual (Page 17)

G1073/G1073Z 16'' Bandsaw -15-
Figure 13. Fence rails properly secured to table.
Figure 14. Fence mounted on rails.
2. Screw the fence locking handle into its posi-
tion on the cam on the fence headstock.
Move it to the loose (up) position.
3. Slide the fence onto the fence rails as shown
in
Figure 14.
Fence
The mounting holes in the rails are not centered
on the length of the rails. This way, you can
mount the rails so that maximum fence travel will
be greater on one side or the other.
To mount the rails:
1. Secure the fence rails to the table with the
four (4)
1 ⁄
4
"-20 x 1 1 ⁄
4
" cap screws and spacers
provided ( Figure 13 ).
Rail Spacers
There are two ways to remove the fence:
1. Remove the blade so the fence slides off
the rails.
2. Dismount the rails by removing the cap
screws.
NOTICE
When the fence is to the left of the blade,
the fence must be positioned near the cen-
ter of the table in order to open the lower
wheel cover.