GE Monogram Outdoor Cooking Center 36 - Manual (Page 25)

25
Burner
removal
(on some models)
(continued)
To remove the range-top burners (on some
models), remove the top grates. Lift out
aeration pan from around the burners. Lift and
remove the front and rear range-top burners.
The smoker burner (on some models) can be
removed and cleaned by unplugging the igniter
wire and lifting out the burner.
When reinstalling burners, make sure all
burners are in the correct position. Burners
should rest flat over the anti-flip bracket (on
some models) with stubs on top and flat side
down. Also, check to make sure all grill burners
are level and securely seated in grill box.
To reassemble the burners, replace the burner
by sliding the air shutters over the brass orifice,
centering it in the hole. It is extremely important
to center the burner on the orifice properly.
(See the Installation Instructions for detailed
directions.)
Be careful not to upset the air shutters’ original
position (unless readjusting). Lower the rear
of the burner into the cutouts on the support
channel and make sure the locating hole in the
burner end is seated over the pin in the burner
box. Make sure all burners are level and do
not rock.
On 24
″
models, to double check if the two
burners are properly seated over the brass
orifices, you can visually inspect them.
1. Remove the two outer control knobs.
2. Remove the two screws underneath the
control knobs and the two screws underneath
the control panel.
3. Rotate the control panel forward. (Do not
remove it.)
4. Shine a flashlight in the gap to make sure the
burners are over the brass orifices. Replace
screws and knobs.
Replace the radiant tray with lava rocks or the
Gourmet Radiant™ trays so that the slots in the
corners of the tray align with the projections on
the top of the burner. (On 24
″
models the
stainless steel radiant trays sit level on the side
supports.) Make sure that it sits level and does
not rock.
Grill burner for 27 ″, 36 ″ and 48 ″ models
Grill burners for 24 ″ model
INCORRECT
Burner is
Upside Down
CORRECT Burner Rests
Level onto Anti-Flip Bracket
Ignitor
Anti-Flip Bracket on
27", 36" and 48" Models
Burner Nubs Should
be on Top
Light all of the burners and check for proper
flame characteristics. (Do not attempt to light
the burners prior to replacing radiant trays,
grills and aeration pans.) If adjustments are
necessary, refer to the Installation Instructions.
″ ″ ″