Graco 7500 - Manual (Page 3)

6 7 8 5 750-5-99
To Assemble Rear Axle
Your stroller will have either a rear axle or a rear axle
assembly with brackets. Follow the appropriate
instructions below.
Rear Axle:
Step 1.
Turn stroller over as shown.
Step 2.
Slide the rear axle through the
holes in both axle brackets.
Rear Axle Assembly:
Step 1.
Turn stroller over as pictured above.
Step 2.
Position rear axle assembly as shown.
Retainer (2,
1 extra)
Rear wheel (2)
Cap (2,
1 extra)
Front wheel
assembly (2)
Basket support wire
(on models with
small basket)
Storage basket
(on certain models)
Pin (2)
Handle
bent
towards
rear
Smooth side of
brackets UP
Button
Rear legs
Step 3.
Push both brackets all the way on until metal buttons snap
into bracket holes on inside of legs.
Pull firmly on each bracket to be sure buttons are
snapped into bracket holes.
To Assemble Rear Wheels
Place one rear wheel, red retainer, and white cap on one
end of rear axle in order as shown below. Push red retainer
onto axle BEFORE attaching white cap. Repeat on other
side.
Wheel
Spokes
toward
inside
Rear
axle
Retainer (red)
Wide end
toward wheel
To Install Storage Basket
(on certain models)
Step 1.
Snap basket support wire
onto rear legs as shown.
Step 2.
Fasten the two straps around front legs, above the side
braces, as shown.
Step 3.
Fasten the bottom row of snaps around the rear axle.
Step 4.
Fasten the top row of snaps around the basket support
wire.
Straps
Snaps
Side
brace
Be sure buttons are securely latched in bracket holes.
Check by pulling firmly up on handle.
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109 or visit our Internet website,
www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY .
No tools required for assembly.
Handle
with
wire
Frame
Handle
without
wire
OR
Swivel lock
button (2)
Step 1.
Snap swivel lock button onto
wheel mount as shown. This
must be done BEFORE pin is
inserted (next step).
Step 2.
Insert pin through hole in wheel
mount. Then push round end of
a front wheel assembly up onto
pin as shown until it snaps into
place.
Check wheel attachment by
pulling down on the front
wheel assembly.
Step 3.
Repeat above steps for the
other side.
Insert pin
Push
wheels up
To Assemble Front Wheels
Snap red retainer into axle
groove. Then snap cap over
red retainer as shown.
Be sure cap is snapped
securely over red retainer.
Cap (white)
Attach AFTER
retainer is on axle
To Unfold Stroller
Step 1.
Unfold footrest from under
armrest.
Step 2.
Release storage latch.
Step 3.
Unfold as shown.
Be certain
the stroller is fully erected
and latched before allowing
your child near the stroller.
OR
Round
end
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Step 2.
Open stroller on
carton as shown
until latched.
Flattened
carton
Latch
Rear axle
assembly
OR
Rear axle
To Install Handle
Step 1.
Turn handle brackets straight up.
Step 2.
Position handle as shown.
Step 3.
Place both sides of handle
into brackets and push down
until latched.
Handle
bracket