Gold's Gym GGEX61607.0 - Manual (Page 5)

5
ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included tools and your own adjustable wrench and Phillips screwdriver .
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled.
If a part is not in the parts bag, check to see if it has been pre-assembled.
M8 Nylon
Locknut (10)–6
M8 Split
Washer (41)–10
M10 Nylon
Locknut (33)–4
M4 x 16mm
Screw (49)–4
M8 x 25mm Button
Screw (45)–6
M10 x 75mm Carriage Bolt (30)–4 M8 x 45mm Button
Screw (9)–2
M8 Curved
Washer (57)–2
M4 x 22mm
Screw (20)–2
1. Identify the Front Stabilizer (2). See the inset drawing.
Attach a Wheel (14) to one end of the Front Stabilizer
with an M8 Nylon Locknut (10). Make sure that the
Wheel is oriented as shown and that it turns
freely. Next, align the four plastic posts on a Wheel
Cover (23) with the plastic posts on the Wheel, and
press the Wheel Cover onto the Wheel. Assemble
the other Wheel (not shown) in the same way.
While another person lifts the front of the Frame (1),
attach the Front Stabilizer (2) to the Frame with two
M10 x 75mm Carriage Bolts (30) and two M10 Nylon
Locknuts (33) as shown.
2
33
30
1
1
2
14
23
10
Post