Grundig YB550PE - Manual (Page 18)

WORKING WITH MEMORY continued WORKING WITH MEMORY continued
M E M O RY S E A R C H
Memory Search enables searching through the memory pre-
sets within a memory page, as shown below:
1. Press/release the M.Scan/Page button.
2. Use quick, short presses on the + or – buttons to search
through the memory presets.
M E M O RY A U T O S C A N
Memory Autoscan enables scanning through the memory pre-
sets within a memory page. The memory being scanned
enables listening to the station for about 5 seconds and will
then move on to the next memory automatically. Autoscan
will continue indefinitely on the selected page until deliber-
ately stopped.
1. Press/release the M.Scan/Page button.
2. Press/hold either the + or – button for about 3 seconds.
Then release it. Note that the memory preset number in
the upper right corner of the display flashes and the pre-
set being scanned remains for about 5 seconds. It then
moves on to the next memory preset for another 5 sec-
onds. To stop memory preset autoscan, press/release
either the + or – button.
35
ACCESSING WHAT IS STORED INTO MEMORY
Below, the three ways to access what has been stored into
memory are described: Direct Memory Access, Memory Search
and Memory Autoscan. When the memory page and memory
preset numbers appear in the upper right corner of the dis-
play, as it will in the sections below, the radio is in MEMORY
ACCESS MODE. This mode can be exited any time with a
press/release of the M.Scan/Page button.
DIRECT MEMORY ACCESS: To directly access a memory pre-
set, the page number and preset number must be entered, as
shown below:
1. Press/hold the M.Scan/Page button for about 3
seconds.Then release it. Note that the memory page is
flashing in the upper right corner of the display.
2. Within 5 seconds select the desired page with the + and
– buttons.
3. Within 5 seconds, use the numeric keypad to key-in the
memory preset number that you wish to access. (if it is
under 10, key in 01, 02, etc.). NOTE: Once a page number
has been selected or changed, even if it is not seen on the
screen, a memory preset on that page can be selected by
keying in the memory number with the numeric keypad,
without having to re-do steps 1 and 2 above.
34
YB 550PE OPERATION MANUAL