Grizzly Low Profile Cement T10095 - Manual (Page 13)

t10095 Cement Mixer -11-
assembly
To assemble the cement mixer:
1. Coat the axle rod in bearing grease, slide
it through the frame, and attach a wheel to
each end with a M10-1.5 x 20 hex bolt and
flat washer, as shown in
Figure 4. (these
fasteners may be preinstalled in the axle
rod.)
Figure 4. Wheels attached to frame.
Figure 5. Frame assembly.
2. Attach the frame support and handles to the
frame with the eight M8-1.25 x 80 hex bolts,
sixteen 8mm curved washers, and eight
M8-1.25 lock nuts, as shown in
Figure 5.
3. Secure the motor to the frame with the six
6mm flat washers, lock washers, and lock
nuts, as shown in
Figure 6.
Figure 6. Motor attached to frame assembly.
4. Attach the motor cover with the two M6-1
x 16 phillips head screws and hex nuts, as
shown in
Figure 7.
Figure 7. Motor cover attached next to motor.
5. turn the assembly around and rest it on its
back, as shown in Figure 8.
Figure 8. Frame assembly on its back.
Motor Cover