Changing blades – Grizzly G1060 User Manual
Page 11

G1060 22'' Scroll Saw
-9-
Changing Blades
SECTION 5: ADJUSTMENTS
1.
Remove Safety Shield assembly.
2.
Remove Table Insert and flip open Chuck
Guards.
Figure 3.
3.
Mount Blade in Chucks. This can be done
with the help of the Chuck Holder, located on
the right edge of the table.
Figure 4.
4.
Mount Chucks between Upper and Lower
Arms (Blade teeth should be pointing down
toward the table) and close Chuck Guard.
Don’t replace the Safety Shield or Table
Insert just yet - wait until after you’ve adjust-
ed blade tension.
Figure 3.
Figure 4.
See also other documents in the category Grizzly Power saws:
- G0506 (56 pages)
- 12" Cold Cut Saw G0682 (52 pages)
- G1127 (3 pages)
- 24" & 27" Resaw Bandsaws G3619 (56 pages)
- H7197 (1 page)
- INDUSTRIAL BANDSAW W/FOOT BRAKE G0513X2F (108 pages)
- Heavy-Duty Table G1023Z (63 pages)
- G0641 (56 pages)
- Air Cut-Off G8122 (2 pages)
- Ultimate 14" Bandsaw G0555 (68 pages)
- G4186Z (48 pages)
- H8145 (36 pages)
- G0691 (11 pages)
- G0691 (92 pages)
- G0592 (60 pages)
- Model G1022proz (84 pages)
- G0605X1-6X1 (12 pages)
- Model G1023zx3 (63 pages)
- G1016 (30 pages)
- H0604 (10 pages)
- ZX (63 pages)
- g0531b (8 pages)
- G3620 (56 pages)
- G1023SL (50 pages)
- G1023SLWX (3 pages)
- 50/65 Ton Ironworker G0647 (76 pages)
- Zero Clearance Table Insert H7396 (1 page)
- H7583 (28 pages)
- G0621 (60 pages)
- G0457 (64 pages)
- G0605X1 (101 pages)
- H0629 (3 pages)
- Slow Speed Cold Cut G0665 (40 pages)
- G0717 (60 pages)
- G0659 (60 pages)
- G0606X1 (12 pages)
- G0605X/G0606X (76 pages)
- G5787 (37 pages)
- G8599 (13 pages)
- T10131 (4 pages)
- G0513P (108 pages)
- G9906 (14 pages)
- G0513X2 (108 pages)
- G7211 (34 pages)
- G1052 (34 pages)