GE Spacemaker Microwave Oven JVM1540 - Manual (Page 33)

Light Bulb Replacement
1 To replace the bulb(s),
first disconnect the power
at the main fuse or circuit
breaker panel or pull the
plug.
2 Remove the screw at the
front of the light cover
and lower the cover.
3 Be sure the bulb(s) to be
replaced are cool before
removing. After breaking
the adhesive seal, remove
the bulb by gently turning.
Replace with the same size
and type bulb.
4 Raise the light shield and
replace the screw.
Connect electrical power
to the oven.
Cooktop Light/
Night Light
1 To replace the oven light,
first disconnect the power
at the main fuse or circuit
breaker panel or pull the
plug.
2 Remove the top grille by
taking out the 2 screws
that hold it in place.
3 Remove the charcoal
filter (if present) to
access the light cover
(see Remove Charcoal
Filter Section)
4 Remove the light cover
located near the center of
the oven that holds the
bulb. After breaking the
adhesive seal, remove the
bulb by gently turning.
Replace with the same size
and type bulb.
5 Replace the light cover
and charcoal filter (if
present)
6 Replace the grille and
screws. Connect electrical
power to the oven.
Oven Light
33
Remove screw
Replace the burned-out
bulb with a 120 volt,
40-watt incandescent bulb
(WB36X10003), available
from your Mabe supplier.
Replace the burned-out
bulb with a 120 volt,
40-watt incandescent bulb
(WB36X10003), available
from your Mabe supplier.
Light Cover
Screws
DTP_EN-EN_350A4502P651.qxd 10/19/2007 10:21 AM Page 33