Grindmaster 5512 - Manual (Page 20)

Page 20 Crathco
®
5512 Manual
Freezer will not run or Freezer not plugged in Plug in machine
freeze down
Circuit breaker tripped or fuse Reset breaker or
blown replace fuse
Freezer in "CLEAN" position Switch to "FREEZE"
Dasher or blades not installed Install dasher and blades
Obstructed cooling air flow Allow 6"(15cm) on sides
Freezer in Standby mode Switch to "FREEZE"
Product too soft Improper consistency control setting Readjust consistency control
Mix soft, no overrun Product broken down
Drain and refill with
fresh mix
Carburetor set incorrectly Readjust carburetor
Extended non-draw period Use "STANDBY" during slow
business periods
Improper product taste Check date code. Use
only fresh mix
Used rerun/leftover mix Use only fresh mix
Frozen product too fluffy and icy Draw out 1 quart (1 liter),
(Product frozen too long, low draw) dispose of product.
Allow product to refreeze.
Frozen product too Consistency control set too firm Readjust consistency control
stiff, or freezer runs Dispensing valve not fully closed Close valve, lubricate
continuously properly
Frozen product not Power switch OFF Turn Power Switch to ON
dispensing Insufficient mix in storage hopper, Refill storage hopper
light on, beeper
Carburetor in off position,
Set carburetor to proper hole
between holes size
Carburetor inlet hole clogged Unclog carburetor
Foam buildup, liquid mix cannot Remove foam from hopper
feed properly using sanitized utensil
Drive belt broken or off of pulley Replace or repair
Machine in STANDBY mode Set switch to FREEZE
Liquid coming out of Worn, defective or improperly Replace and lubricate per
drain tube, front of installed seal manual
freezer
PROBLEM PROBABLE CAUSE SOLUTION
Troubleshooting Guide
Only a qualified service technician should perform electrical and mechanical adjustments
or repairs. Always disconnect power before attempting any maintenance procedures.
!