Stovax AR0368 - Manual (Page 17)

17
SERVICING INSTRUCTIONS
REPLACING PARTS
1.1 All principal components can be replaced without removing
the stove from its installation, although it will be necessary
to remove the door and steel outer casing in order to access
most components. In order to remove the casing, using the
following procedure:
1.2 Lift off the decorative steel trim see diagram 1 and remove
the 6 screws holding the glass frame. See diagram 2.
1.3 Carefully remove the top blanking plate and cast iron grille
and place to one side, remove the steel top, see diagram
16. If the unit has been connected to the top exit flue, it
will be necessary to lift the support the grille and steep top
whilst removing the outer steel casing.
1.4 Remove the two front panels as shown. See diagrams 3 and
4.
1.5 Lift the RH decorative panel to disengage from its locating
brackets and remove from the stove, see diagram 4. It may
not be necessary to remove the LH side.
1.6 This should allow full access to all major components.
1
2
AR0887
3
1. GENERAL
4
AR0879
AR0878
5