Grundig Platinum PVR Remote Control User Manual

Page 29

108933

ROUBLE

-S

HOOT THE

EMOTE

ONTROL

What’s

Happening

What’s Wrong

What You Can Do

While you
do a remote
procedure, the
remote control
“times out.”

If you don’t press
any button
for 20 seconds,
the remote “times
out.”

Start over again.

You can’t find
the remote
control.

• Maybe you lost the

remote control.

• Maybe someone

else has the remote.

• Use the receiver’s front panel buttons

to control the receiver until you find
the remote.

• If the remote control is lost for good or

too damaged to use, please call the
Customer Service Center to order a
replacement. You’ll have to pay
for the new remote control,
plus shipping and handling.

When you
press the
remote control

Power

button

to turn the
receiver on,
the receiver’s
front panel

Power

light

doesn’t turn
on.

• Maybe you can’t

see if the receiver

Power

light is on,

if other lights in the
room are too
bright.

• Maybe the remote

control isn’t
working right or
the batteries are
weak or dead.

• Maybe you didn’t

plug the receiver
power cord into a
power outlet, or
maybe there’s a
problem with the
power.

• Maybe the remote

isn’t in

Sat

mode.

• Maybe the remote

and the receiver
have different
addresses.

• Turn down the other room lights so you

can see if the receiver

Power

light

is on.

• Try other remote control buttons to see

if the receiver responds. Replace the
remote batteries with fresh ones.

• Make sure the receiver power cord

is okay, and the put the plug into the
outlet the right way.

• Make sure you set the remote to

Sat

mode to control the receiver.

• Make sure the remote and the receiver

have the same address.

You set up the
remote control
for the

mode. Then,
you find you
can’t set up the
remote control
for the

Aux

mode.

For a few remote
controls you must set
up the

Aux

mode

before you set up the

mode.

Do these things: (a) write down the
TV code, (b) reset the

mode with

code 222, (c) set up the

Aux

mode, and

(d) reset the

mode with the code

you wrote down in step (a).

text_dishpvr.fm Page 27 Thursday, July 12, 2001 10:02 AM