beautypg.com

Gravely 988117 - HR1536FX User Manual

Page 18

background image

GB - 18

988116, 117, 120, 314

To test:

1. With engine off, set controls as listed in line A of

the table below.

2. Try starting the engine. See Starting and Shut Off

on page 13.

IMPORTANT: If the system does not function properly,
do not operate the unit until repairs are made.

3. Repeat steps 1-2 for lines B-C of the table below.

4. Shut off the unit, if necessary. See Shut Off and

"To stop mowing."

5. With the engine running, set controls as listed in

lines D -G of the table below.

IMPORTANT: If the system does not function properly,
do not operate the unit until repairs are made.

* Note: Unit will not start if both operator presence
control levers are engaged.

** Note: Engine stops if both operator presence control
levers are released while parking brake is off.

CHECK AIR CLEANER

Check the air cleaner element before each use. See
engine manual for detailed instructions.

CHECK ENGINE OIL

Check the engine oil level before each use. Never
operate the engine when the oil level is low. See engine
manual for detailed instructions.

CHECK ENGINE COOLING

Check the engine air cooling system before each use.
See engine manual for detailed instructions.

CHECK FASTENERS

Check all nuts, bolts, and other fasteners before each
use. Replace missing or damaged fasteners.

CHECK TIRE PRESSURE

Check tires for proper inflation, excessive wear or
damage before each use. The correct air pressure is
8 to 16 psi (55 to 110 kPa).

CHECK HYDRAULIC FLUID LEVEL

Check the hydraulic fluid level with the dipstick before
each use (more often if leaks are observed). Stop the
engine before servicing any hydraulic parts.

1. Run unit until warm.

2. Shut off engine.

3. Unscrew tank cap to remove cap/dipstick.

NOTE: Do not allow any dirt to get into the system.

4. Wipe dipstick clean.

5. Screw cap/dipstick back into tank.

6. Remove cap/dipstick and check hydraulic oil level

mark.

7. Add hydraulic fluid as needed. Do not overfill. See

Specifications for hydraulic fluid type.

CHECK BATTERY (988108, 109, 117)

Terminals

Inspect battery and terminals every 25 hours.

PT

O

P

ARKING BRAKE

OPERA

T

OR PRESENCE

CONTR

OL

ENGINE

A

Off

Off

Off

Won’t Start

B

Off

On

Off

Starts

C

Off

On

On*

Starts

D

Won’t Run

On

Off

Runs

E

On/Off

Off

Off**

Stops

F

Off

Off

Off

Stops

G

Off

On

Off

Runs

WARNING: HYDRAULIC FLUID UNDER
PRESSURE
can penetrate skin and cause
severe burns that can result in death or
serious injury.

ALWAYS keep body and hands away from
pin holes or nozzles which eject hydraulic
fluid under pressure. ALWAYS use paper or
cardboard and not hands to search for leaks.

KNOW that all hydraulic fluid connections
are tight and all hydraulic hoses and lines
are in good condition BEFORE applying
pressure to system.

Foreign fluid injected into skin must be
surgically removed within a few hours by a
doctor familiar with this form of injury or
gangrene may result.

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.

WARNING: Battery posts, terminals and
related accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.