Filtera 17005 - Manual (Page 5)

NOTE: The air cleaner cannot be programmed unless it is plugged into the outlet.
To SET program points:
Press the SET button and hold for 3 seconds to activate time function. The SET
button will move through these programming functions:
Set (current) TIME.
Set PG1 cycle times P1-ON and P1-OFF.
Set PG2 cycle times P1-ON and P1-OFF, and P2-ON and P2-OFF.
Set EXIT mode and Run the clock.
To Customize the PG1 Program Settings to run ONE ON/OFF Cycle in a 24 hour
period:
NOTE: You are unable to set the OFF time to be the same as the ON time.
• Press the SET button and hold for 3 seconds to activate time function. Move
through programming functions by repeatedly pressing SET button until PG1 and
P1-ON appear. The clock and program speed icons will appear (Fig. 4a).
• Adjust the time using the hours and minutes button (up for hours, down for
minutes). This is the time that the machine will turn ON.
• Adjust the desired speed setting using the SPEED button.
• Press the SET button until PG1 and P1-OFF appear. The speed icon will disappear
(Fig. 4b).
• Adjust the time using the hours and minutes button. This is the time that the
machine will turn OFF.
• Repeatedly press SET button until ( ) disappears.
• Press the PROGRAM button until PG1 appears. Unit will automatically operate per
your settings.
Customize Program Cycles
Fig. 4a Fig. 4b
To run one pre-set program cycle in a 24 hour period (PG1).
PG1 Pre-Setting to run Program One
P1-ON 4 PM HIGH SPEED
P1-OFF 8 AM
To activate pre-set PG1, Press the PROGRAM button once. PG1 will be displayed.
Your machine is now programmed to run from 4pm to 8am on HIGH (Fig. 3a, 3b).
Pre-Set Program Cycle
Fig. 3a Fig. 3b
035-00438 17005 OM eng/fr/sp 8/3/01 12:44 PM Page 5