Firstech, LLC. CM4200 User Manual
Firstech, LLC. Televisions
This manual is related to the following products:
Table of contents
Document Outline
- Master Install Guide
- CONNECTOR 1
- CONNECTOR 2
- CONNECTOR 3
- CONNECTOR 4
- CONNECTOR 5
- CONNECTOR 6
- (Pre-wired L.E.D.)
- CONNECTOR 7
- (Pre-wired Shock Sensor)
- CONNECTOR 8
- (Optional add on sensors; i.e. proximity)
- CONNECTOR 9
- (Pre-wired Remote Paging Sensor or R.P.S.)
- CONNECTOR 10
- (Optional Temperature sensor)
- CONNECTOR 11
- (Pre-wired Antenna Cable)
- CONNECTOR 1
- CONNECTOR 2
- CONNECTOR 3
- CONNECTOR 4
- CONNECTOR 5
- (Pre-wired L.E.D.)
- CONNECTOR 6
- (Pre-wired Shock Sensor)
- CONNECTOR 7
- (Pre-wired Remote Paging Sensor or R.P.S.)
- CONNECTOR 8
- (Pre-wired Antenna Cable)
- CONNECTOR 1
- CONNECTOR 2
- CONNECTOR 3
- CONNECTOR 4
- CONNECTOR 5
- (Optional Temperature sensor)
- CONNECTOR 6
- (Pre-wired Antenna Cable)
- CONNECTOR 7
- RS 232
- CONNECTOR 1
- CONNECTOR 2
- CONNECTOR 3
- CONNECTOR 4
- (Pre-wired L.E.D.)
- CONNECTOR 5
- (Pre-wired Shock Sensor)
- Resetting all of Menu #1 or Menu #2
- Options Explained In Detail CM3000-3300-4200
- Additional Programming
- Common Diagrams
- Note: This diagram will not work with all turbo timers.
- Starter Kill Relay Installation
- Adding a Relay to Power a Secondary
- Ignition, Accessory, or Starter
- Adding Aftermarket Alarm Accessories
- Using the Ground While Armed Output
- Accessory Manuals
- OP500 Option Programmer
- Note1: The USB interface cable is for future use to connect the OP500 to a computer. Once the software for this feature is complete, additional instructions will be supplied.
- Channel Expander
- The channel expander is an add-on module that can be used to expand the existing two auxiliary outputs to a total of seven auxiliary outputs. Each one of these seven outputs can be individually programmed for pulsed, latched, or timed-latch output. The programming of the Channel Expander outputs must be done with the Option Programmer; the CompuStar remotes do not have the ability to access these programming options.
- Please note that the Auxiliary outputs are low-level outputs, and should not
- Programming the Outputs
- RPS – Remote Paging Sensor
- Temperature Sensor