FUJITSU FTR-G1 - Manual (Page 5)

5
FTR-K1 SERIES FTR-G1 SERIES
1. General Information

All automotive relays produced by Fujitsu Components are compliant with RoHS directive 2002/95EC
including amendments.

Cadmium as used in electrical contacts is exempted from the RoHS directives on October 21st, 2005.
(Amendment to Directive 2002/95/EC)

All our automotive relays are lead-free.

Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specifi ed.
This material has been verifi ed to be compatible with PbSn assembly process.
2. Recommended Lead Free Solder Profi le

Recommended solder Sn-3.0Ag-0.5Cu.
RoHS Compliance and Lead Free Information
3. Moisture Sensitivity

Moisture Sensitivity Level standard is not applicable to through hole mounted electromechanical relays, unless
otherwise indicated.
4. Tin Whiskers

Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length
whisker was found by our in house test.
We highly recommend that you confi rm your actual solder conditions
Flow Solder condition:
Pre-heating: maximum 120˚C
Soldering: dip within 5 sec. at
260˚C solder bath
Solder by Soldering Iron:
Soldering Iron
Temperature: maximum
360˚C
Duration: maximum 3 sec.