Cli commands – Foundry Networks LS 648 User Manual
Page 51

Maintaining the FastIron LS Hardware
September 2007
© 2007 Foundry Networks, Inc.
5 - 9
•
100FX-LR
CLI Commands
The show media command displays module information including link length, vendor name, vendor part number,
vendor revision, and laser wavelength.
[no] optical-monitor
Use this command to configure monitoring for all ports (system-wide), a range or ports, or a single port. The
interval is three minutes. When monitoring is enabled, console messages, syslog messages, and SNMP traps are
sent when warranted by optical operating conditions, and a port is enabled.
show optic port/slot_number
This command displays optical monitoring information as a result of the optical-monitor configuration command.
Information includes:
•
temperature
•
TX power
•
RX power
•
TX bias current
Status values are:
•
low-alarm
•
low-warn
•
normal
•
high-warn
high-alarm